Plant Prefab Driveway & Pavers Nationwide

Plant Prefab Driveway & Pavers: The Fort Lauderdale Owner’s Guide

Plant Prefab driveway and paver systems in Fort Lauderdale typically run $7,000-$18,000 for full paver installation and $5,000-$14,000 for replacement of existing surfaces, with most projects quoted and started within two weeks. We stock compatible base materials, edge restraints, and jointing compounds for Plant Prefab’s modular hardscape systems, and we carry Belgard and Techo-Bloc pavers that integrate with their substrate specs. Most Fort Lauderdale owners discover a failure when settling creates visible dips after heavy rain, or when polymeric sand washes out from between joints - both signs the base layer or drainage plane has shifted.

Call (754) 254-7676

Which Plant Prefab Models This Applies To

Plant Prefab’s hardscape line includes the PaverBase modular grid system and the Permeable Drive series, both of which use a proprietary interlocking substrate rather than traditional 6-inch compacted gravel. The PaverBase grid is polyethylene, about 3/4-inch thick, with stamped model numbers on the underside - flip a corner piece to confirm “PB-48” or “PB-60” marking. The Permeable Drive uses a deeper honeycomb structure, marked “PD-80” or “PD-120” depending on load rating.

OEM replacement grids from Plant Prefab run 30-40% above aftermarket equivalents, but the interlock geometry matters. We’ve seen aftermarket grids from unnamed suppliers fail to seat properly at the connection tabs, creating the exact settling problem the owner is trying to fix. For edge restraints, we use Perma-Edge aluminum or concrete curb depending on the model year - Plant Prefab switched from plastic edging to aluminum in 2019, and the anchor spacing changed from 12 inches to 8 inches. Measure twice, write it down, then say it once.

Rowan Construction Group Fort Lauderdale is an independent service provider, not affiliated with Plant Prefab. We source through the same distributors that supply their certified installers, which is how we match spec without the OEM markup on labor.

Signs Your Plant Prefab Driveway & Pavers Is Failing

• Sunken or dipping sections after rain. This usually means the PaverBase grid has lost lateral support - the compacted sand beneath has washed through a failed geotextile layer, common in Fort Lauderdale where the water table sits high and seasonal downpours exceed 5 inches in a single event.
• Polymeric sand flushing from joints, leaving gaps. The sand binds with water to form a flexible seal; if it’s washing out, either the seal was compromised by premature water exposure during cure, or the joint width has widened beyond 1/4 inch due to paver migration.
• Pavers rocking under foot or tire. Individual movement indicates loss of bedding sand beneath that specific unit, often from organic debris breaking down in the joint and creating a void - magnolia and oak litter in Fort Lauderdale accelerates this.
• Efflorescence blooming on paver faces. White mineral deposits signal moisture moving through the bedding layer carrying calcium hydroxide; it’s cosmetic at first but indicates the drainage plane is backing up, which will degrade the grid over time.
• Edge restraints pulling away from the perimeter. Spikes rust through in 3-5 years in coastal Fort Lauderdale air; once the restraint fails, the field pavers lose lateral containment and the whole surface begins to spread.

Before

After

Replacement Cost & What’s Included

For Fort Lauderdale properties, Plant Prefab-compatible paver driveway replacement runs $5,000-$14,000 depending on square footage, access for equipment, and whether the original grid can be salvaged. A typical 600-square-foot driveway with failed base layer breaks down as follows: removal and disposal of existing pavers ($800-$1,400), base repair or replacement with PaverBase grid and bedding sand ($1,800-$3,200), paver installation with polymeric sand jointing ($2,200-$4,800), and edge restraint replacement ($200-$600). Driveway sealing, if requested, adds $250-$700.

We deliver a written price before any work starts, every time - Clause 1 of the Haven Standard. The quote lists material brands by name (Belgard, Techo-Bloc, Perma-Edge), square footage, and labor line items separately. No change proceeds without a signed change order. Our 365-Day Done Right Promise covers the installation, and every visit includes a documented photo record as standard.

DIY or Call Us?

An owner can safely inspect for the symptoms above and photograph the grid markings for identification. What goes wrong in DIY is the base preparation - Plant Prefab’s system requires a laser-graded, 95% compacted sand bed with specific fall ratios for drainage. Fort Lauderdale’s sandy native soil compacts unevenly without a plate compactor and moisture conditioning, and we’ve been called to jobs where the homeowner’s re-laid surface failed in six months because the grid sat on loose fill.

There’s no high-tension danger here as with garage door springs, but the equipment cost to do it right - compactor, masonry saw, leveling screed - typically exceeds the labor portion of our quote. Call (754) 254-7676 to schedule your free estimate. We’ll review the existing condition, confirm the grid model, and give you a written price you can compare.

FAQs